ISO/TS 11686:2017
Connectors for fluid power and general use — Assembly instructions for connectors with adjustable stud ends and O-ring sealing
ISO/TS 11686:2017 provides common installation instructions for all connectors that have adjustable stud ends and O-ring sealing. Conformance with the requirements of this document will result in a considerable reduction of leaks in hydraulic systems.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$126.00 NZD
|
|
| Networkable PDF |
Price varies
|
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Instructions for the assembly of connectors with adjustable stud ends and O‑ring sealing
4.1 Preparation prior to assembly
4.2 Assembly
4.2.1 Illustration
4.2.2 Location of O-ring (position 1 in Figure 1)
4.2.3 Positioning of locknut (position 2 in Figure 1)
4.2.4 Installation of connector into the port (position 3 in Figure 1)
4.2.5 Connector adjustment (position 4 in Figure 1)
4.2.6 Final tightening (position 5 in Figure 1)
4.2.7 Final inspection
Annex A (informative) Identification of ports, stud ends and plugs and potential for incompatible intermixing
Bibliography
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
AS/NZS 2280:2020
Ductile iron pipes and fittings -
AS/NZS 2280:2020 A1
Ductile iron pipes & fittings
-
BS 5200:1997
Specification for dimensions of hydraulic connectors and adaptors
-
BS 5242-2:1983
Tubes for fluid power cylinder barrels, Specification for non-ferrous metallic tubes with specially finished bores
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Instructions for the assembly of connectors with adjustable stud ends and O‑ring sealing
4.1 Preparation prior to assembly
4.2 Assembly
4.2.1 Illustration
4.2.2 Location of O-ring (position 1 in Figure 1)
4.2.3 Positioning of locknut (position 2 in Figure 1)
4.2.4 Installation of connector into the port (position 3 in Figure 1)
4.2.5 Connector adjustment (position 4 in Figure 1)
4.2.6 Final tightening (position 5 in Figure 1)
4.2.7 Final inspection
Annex A (informative) Identification of ports, stud ends and plugs and potential for incompatible intermixing
Bibliography