ISO 3506-1:2009
Mechanical properties of corrosion-resistant stainless steel fasteners — Part 1: Bolts, screws and studs
ISO 3506-1:2009 specifies the mechanical properties of bolts, screws and studs made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient temperature range of 10 °C to 35 °C. Properties vary at higher or lower temperatures.
ISO 3506-1:2009 applies to bolts, screws and studs
- with nominal thread diameter d ≤ 39 mm,
- of triangular ISO metric threads with diameters and pitches in accordance with ISO 68-1, ISO 261 and ISO 262, and
- of any shape.
It does not apply to screws with special properties, such as weldability.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$126.00 NZD
|
|
| HardCopy |
$173.00 NZD
|
|
| Networkable PDF |
Price varies
|
Scope
Normative references
Symbols
Designation, marking and finish
Designation
Marking
General
Manufacturer's identification mark
Bolts and screws
Studs
Packages
Finish
Chemical composition
Mechanical properties
Testing
Test programme
Test methods
General
Tensile strength, Rm
Stress at 0,2 % permanent strain, Rp0,2
Elongation after fracture, A
Breaking torque, MB
Test for strength under wedge loading of full size martensit
Hardness HB, HRC or HV
Previous versions
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
AS/NZS 1252.1:2016
High-strength steel fastener assemblies for structural engineering - Bolts, nuts and washers - Part 1: Technical requirements -
AS/NZS 1252.1:2016 A1
High-strength steel fastener assemblies for structural engineering - Bolts, nuts and washers - Part 1: Technical requirements: Amendment 1:2018 -
AS/NZS 1252.2:2016
High-strength steel fastener assemblies for structural engineering - Bolts, nuts and washers - Part 2: Verification testing for bolt assemblies -
AS/NZS 1390:1997
Cup head bolts with ISO metric coarse pitch threads
Scope
Normative references
Symbols
Designation, marking and finish
Designation
Marking
General
Manufacturer's identification mark
Bolts and screws
Studs
Packages
Finish
Chemical composition
Mechanical properties
Testing
Test programme
Test methods
General
Tensile strength, Rm
Stress at 0,2 % permanent strain, Rp0,2
Elongation after fracture, A
Breaking torque, MB
Test for strength under wedge loading of full size martensit
Hardness HB, HRC or HV