NZS 6101.3:1991
Classification of hazardous areas - Specific occupancies (flammable gas and vapour atmospheres)
Based on AS 2430:Part 3-1987 with amendments to suit New Zealand requirements. Specifies classification of specific occupancies and provides a means of compliance with the Dangerous Goods Regulations.
| Get this standard | Prices exclude GST | |
|---|---|---|
| HardCopy |
$50.00 NZD
|
|
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Approved Code Of Practice For Safety And Health In The Manufacture Of Paint, Printing Inks And Resins
Ministry: WorkSafe New Zealand
Section: 5.4.3.2(d)
Citation context:Where an area is designated as a “hazardous area” as detailed in NZS 6101, see appendix 3, all electrical installations must be suitable for use in that area.
Code Of Practice For The Design, Installation And Operation Of Underground Petroleum Storage Systems
Ministry: WorkSafe New Zealand
Section: 9.8 Electncal Equipment
Citation context:The requirements regarding electrical installations may be determined by applying the principle of zoning into regions of differing degrees of hazard in accordance with a code or Standard Specificiation as may be approved by the Chief Inspector of Dangero
Code Of Practice For The Transport And Disposal Of Petroleum Storage Tanks And Related Waste
Ministry: WorkSafe New Zealand
Section: 7.7 Electrical Equipment
Citation context:Any electrical equipment can be a possible source of ignition. Where any petroleum products vapours or related wastes may be present, the location of these hazards must be considered and hazardous areas identified. The requirements regarding electrical in
Code Of Practice For The Transport And Disposal Of Petroleum Storage Tanks And Related Waste
Ministry: WorkSafe New Zealand
Section: 8.4 Safety Procedures
Citation context:All electrical equipment shall be located in accordance with NZS 6101, Parts 1 and 3, and must conform to the requirements of the Chief Electrical Inspector, Ministry of Commerce.
Similar Standards
-
AS/NZS 1299:2009
Electrical equipment for mines and quarries - Explosion-protected three-phase restrained plugs and receptacles for working voltages up to and including 3.3 kV
-
AS/NZS 1299:2009 A1
Electrical equipment for mines and quarries - Explosion-protected three-phase restrained plugs and receptacles for working voltages up to and including 3.3 kV: Amendment 1:2012 -
AS/NZS 1300:2009
Electrical equipment for mines and quarries - Bolted explosion-protected three-phase cable coupling devices
-
AS/NZS 1300:2009 A1
Electrical equipment for mines and quarries - Bolted explosion-protected three-phase cable coupling devices: Amendment 1:2012