ISO 14405-2:2011
Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear sizes
ISO 14405-2:2011 illustrates the use of geometrical tolerancing for dimensions that are not linear sizes to avoid the ambiguity that the use of ± tolerances on these dimensions causes. Both linear and angular dimensions, except size of features of size, are covered.
Dimensional tolerancing can be indicated by ± tolerancing or geometrical tolerancing.
The ambiguity caused by using ± tolerances for dimensions other than linear sizes is explained in an informative annex.
| Get this standard | Prices exclude GST | |
|---|---|---|
| PDF ( Single user document) |
$118.26 NZD
|
|
| HardCopy |
$152.17 NZD
|
|
| Networkable PDF |
Price varies
|
1 Scope
2 Normative references
3 Terms and definitions
4 Principles and rules for indication of dimensions and related tolerances
5 Units used in drawings for dimensions
6 Indication of tolerances for linear and angular dimensions
7 Illustrations of ambiguous ( tolerancing vs. unambiguous geometrical tolerancing
7.1 General
7.2 Linear distance between two integral features
7.3 Linear distance between an integral and a derived feature
7.4 Linear distance between two derived features
7.5 Radius dimension
7.6 Linear distance between non-planar integral features
7.7 Linear distance in two directions
8 Angular tolerancing
8.1 Plus/minus tolerancing applied to angular distance
8.2 Examples of geometrical tolerancing applied to angular distance between two integral features
8.3 Angular distance between an integral feature and a derived feature
Keep me up-to-date
Sign up to receive updates when there are changes to this standard
Related Information
Similar Standards
-
BS 1916-1:2009
Limits and fits for engineering, Guide to limits and tolerances
-
BS 1916-2:2009
Limits and fits for engineering, Guide to the selection of fits in BS 1916-1
-
BS 1916-3:2009
Limits and fits for engineering, Guide to tolerances, limits and fits for large diameters
-
BS 2856:1973
Precise conversion of inch and metric sizes on engineering drawings
1 Scope
2 Normative references
3 Terms and definitions
4 Principles and rules for indication of dimensions and related tolerances
5 Units used in drawings for dimensions
6 Indication of tolerances for linear and angular dimensions
7 Illustrations of ambiguous ( tolerancing vs. unambiguous geometrical tolerancing
7.1 General
7.2 Linear distance between two integral features
7.3 Linear distance between an integral and a derived feature
7.4 Linear distance between two derived features
7.5 Radius dimension
7.6 Linear distance between non-planar integral features
7.7 Linear distance in two directions
8 Angular tolerancing
8.1 Plus/minus tolerancing applied to angular distance
8.2 Examples of geometrical tolerancing applied to angular distance between two integral features
8.3 Angular distance between an integral feature and a derived feature